Hammer crusher installation requirements
2017-02-08
Hammer crusher is a high speed vibrating machines, mainly by the impact crushing material. The material enters the crusher, subjected to high-speed rotary impact hammer and broken. So, when installed, the foundation should be done with the other basic vibration isolation measures or separation. So, in the installation process should pay attention to what problems? The following is the hammer crusher installation requirements:
1 hammer crusher should be installed on a concrete foundation, between the two should be padded with hardwood plate or other damping material, the vibration effect of surrounding buildings to work.
2 installation, the motor and the rotor shaft center should be flat, so as not to affect the protection of the protective film premature damage caused by bearing heating.
3 design foundation, to set aside the discharging groove, the inclination of not less than 50 degrees, but the user can also according to the self feeder and transport equipment.
4 before installation, if the base points are found to differ in elevation, large slope. Will be placed directly on the basis of the plate adjustment, or will ensure that the level of fundamentals leveled.
5 the motor should be in the opposite direction of the feed inlet. Then, the electrical equipment location is easy to use.
6 after the installation of hammer crusher, the need to check the equipment on the various parts of the bolt is loose, check whether the main warehouse door is tight, such as not fastening, you need to tighten in a timely manner.
7 in all aspects of the inspection is completed, the need for hammer crusher air load test, if the test is normal, can be normal production.
Hot Product
.png)
