Analysis what are the causes of crusher production capacity decline
2016-02-18
Analysis what are the causes of crusher production capacity decline
Crusher production capacity refers to the unit time crushing material, the unit of general use: tons/hour.Crusher in unit time how many directly decides the final ore dressing process of broken ore production.Crusher is the lifeline of mineral processing equipment, improve the crusher production capacity will bring more benefit for you.
Analysis what factors caused by a decline in crusher production capacity?
1, material hardness.More hard material broken up more difficult, and the more serious wear and tear of equipment.Broken slowly, of course, crushing capacity is small.This needs us in the choice of materials to be moderate.
2, material moisture, that is, the material of the moisture content of large material in crusher easy adhesion, also easy to jam in the process of the material transporting, crushing capacity decreases.To solve this problem, first, at the time of material choice to strictly control the humidity of materials, if the choice of material of humidity, can use the sunshine or dry way to reduce the percentage of moisture in the material.
After 3, broken material fineness, high fineness requirement, which requires broken out of the material is fine, the crushing capacity is smaller.It depends on specific demands of concentrator, if no special requirements, general of the fineness of the material can be set in the system for fine.
Before 4, the composition of the material, the broken material containing fine powder in the more the impact broken, because the fine powder is easy to adhere to affect delivery.So for fine powder content more material should be in advance through a sieve.The fine powder from material selection, as far as possible so as not to affect the normal work of the crusher.
5, the viscosity of the material.The greater the viscosity of the material, the more easy to adhere to.The viscosity of the material adhesion in the crusher in the crushing cavity wall, such as not clean up in time, will seriously affect the working efficiency of the crusher, serious still can affect the normal work of the crusher.Therefore, when selecting a material, it is important to note that the viscosity of the material can't be too big.
6, crushing equipment of broken pieces (hammer head, hubei board) the greater the resistance to wear, the better crushing capacity, if you don't wear, will impact crushing ability.On this aspect, must be broken pieces of crusher maintenance on a regular basis.If there is any breakage or damage after the prompt for replacement, so as not to affect the normal work of the crusher.
Hot Product
